Black BLK-IPE101 Manual de usuario descargar pdf (Pagina 15)

13H.264 Network Video Encoder

SECTION 2: INSTALLATION AND SETUP

To connect a sensor to the encoder:

1. Route sensor wiring to the encoder.

2. Strip 1/4” of insulation from one sensor’s sense and ground wires and insert them into the upper

terminal block in the DI ch 1 and DI GND pin locations, respectively.

3. Strip 1/4” of insulation from another sensor’s sense and ground wires and insert them into the

upper terminal block in the DI ch 2 and DI GND pin locations, respectively.

2.7.3 Digital out (DO) connection

The encoder supports up to two digital out connections to reporting devices in the conguration shown in

the schematic below.

Digital out wiring schematic

To connect digital out reporting device to the encoder:

1. Route leads from the digital out devices to the encoder.

2. Strip 1/4” of insulation from one device’s signal and ground wires and insert them into the lower

terminal block in the DO ch 1 and DO GND pin locations, respectively.

3. Strip 1/4” of insulation from another device’s signal and ground wires and insert them into the lower

terminal block in the DO ch 2 and DO GND pin locations, respectively.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Sin comentarios

Black BLK-IPE101 Manual de usuario Pagina 15