Black BLK-IPE4101 Manual de usuario descargar pdf (Pagina 11)

94-Channel H.264 Network Video Encoder

SECTION 2: INSTALLATION AND SETUP

Digital out wiring schematic

To connect digital out reporting device to the encoder:

1. Route leads from the digital out devices to the encoder.

2. Strip 1/4” of insulation from one device’s signal and ground wires and insert them into the lower terminal block in the DO ch

1 and DO GND pin locations, respectively.

3. Strip 1/4” of insulation from another device’s signal and ground wires and insert them into the lower terminal block in the DO

ch 2 and DO GND pin locations, respectively.

2.4.4 RS-485 device connection

The encoder provides one RS-485 interface connection. The wiring signal polarity and ground to the lower terminal block are

shown in the schematic below.

RS-485 device wiring schematic

To connect an RS-485 device wiring to the encoder:

1. Route wiring from the RS-485 device interface to the encoder.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Sin comentarios

Black BLK-IPE4101 Manual de usuario Pagina 11