Black BLK-IPE4101 Manual de usuario descargar pdf (Pagina 10)

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

CAUTION



Do not exceed the maximum input voltage or the relay switching rate. Refer to specications in this manual

for more information.

Voltage type sensor wiring schematic

Relay type sensor wiring schematic

To connect a sensor to the encoder:

1. Route sensor wiring to the encoder.

2. Strip 1/4” of insulation from one sensor’s sense and ground wires and insert them into the upper 8-pin terminal block in the

DI (for channel 1, 2, 3, or 4) and DI Ground pin locations, respectively.

3. Strip 1/4” of insulation from another sensor’s sense and ground wires and insert them into the upper 8-pin terminal block in

the Ground pin locations, respectively.

2.4.3 Digital out (DO) connection

The encoder supports up to four digital out connections to reporting devices in the conguration shown in the schematic below.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sin comentarios

Black BLK-IPE4101 Manual de usuario Pagina 10