Black BLK-HDPTZ12 Manual de usuario descargar pdf (Pagina 11)

52MP 12X PTZ HD-SDI/HDcctv Dome Camera

SECTION 2: INSTALLATION

2. Drill holes in the mounting surface for the wall anchors (if used) or mounting bolts.

— If the network cables will be routed into the mounting bracket where it attaches to the wall, drill an appropriate hole

for the network cables.

3. Attach the mounting bracket securely to the mounting surface using appropriate mounting hardware.

4. If conduit will be used to shield the network cables, install the conduit and attached it to the mounting bracket.

5. Remove the cable access cover from the mounting bracket.

6. Route the network cables (RS-485, alarm in/out, HD-SDI video, 24 Vac power leads) into the mounting bracket.

2.3 Set the camera hardware conguration switches

The camera hardware conguration switches are located inside the camera module. These conguration switches set the camera

device ID, video mode (NTSC or PAL), and RS-485 protocol, baud rate, and termination state.

1. Remove the camera module from the packaging and place it on a at, clean surface.

2. Remove the three screws securing the dome cover and set it apart from the camera module. Note that the dome cover is

connected to the camera module with a retaining cable (not shown below).

Camera module

Safety cable

Drop

cable

Dome

cover

Dome cover screws

3. Set the hardware conguration switches as required for your installation. Switch functions are described below.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Sin comentarios

Black BLK-HDPTZ12 Manual de usuario Pagina 11