Black BLK-IPS103 Manual de usuario descargar pdf (Pagina 11)

9H.264 Network IP Camera User Manual

SECTION 2: INSTALLATION AND SETUP

Relay type alarm wiring schematic

To connect an alarm reporting device to the camera, strip 1/4” of insulation from the alarm wires and insert them into the terminal

block in the DO pin locations shown above. The pin marked “C” is the common (COM) pin.

2.4.4 RS-485 device connection

The camera provides one RS-485 interface connection. The wiring signal polarity to the connector block is shown in the schematic

below.

RS-485 device wiring schematic

To connect an RS-485 device wiring to the camera, strip 1/4” of insulation from the wires and insert them into the terminal block in

the RS-485 pin locations shown above. Observe the signal polarity shown in the schematic.

2.4.5 Video out connection

The camera provides one BNC analog video connector for setup and a local video monitor. Attach a BNC cable (not provided)

between the camera Loop Out connector and a monitor as needed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sin comentarios

Black BLK-IPS103 Manual de usuario Pagina 11