Black BLK-IPS103 Manual de usuario descargar pdf (Pagina 16)

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

— Check the network for compatibility with the default static network settings of your camera.

— Find network settings (IP addresses) that are not in use and can be assigned to your camera.

— Attach your camera to the network, power it on, and conguring it with new network settings.

Determine the network settings of your computer

1. At a PC attached to the same LAN that will be shared with your camera, determine the IP address, subnet mask, and default

gateway of your PC and record it in Table 1. To nd this information, do the following at the Windows desktop:

a. Hold down the Windows key and press r to open the Run dialog box.

b. Type cmd in the entry eld, then click OK to open the DOS command window.

c. At the command prompt, enter ipcong. The response will show the your PC’s network settings.

Example: Typical use of ipcong in Windows XP

d. Enter the IP Address, Subnet Mask, and Default Gateway for your PC’s Ethernet adapter into Table 1.

NOTE

The Ethernet adapter data you see by using ipcong will probably be dierent from that shown in the example

above. If you are using Windows Vista or Windows 7, the IP address is identied as the “IPv4 Address.”

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

Black BLK-IPS103 Manual de usuario Pagina 16