Black BLK-CPV700R Manual de usuario descargar pdf (Pagina 12)

SECTION 2: INSTALLATION

2. Remove the dome from the camera by loosing the four captive dome screws using the Torx L-wrench provided (BLK-CPV700

series) or inserting a coin into the slot on the side of the camera to pry it o (BLK-CPD700 series).

3. Remove the camera module from the base by loosing the three captive screws that secure the camera module to the base.

4. If you are installing a BLK-CPV700 series camera, position the base seal appropriately onto the base.

5. Route the camera drop cable through the hole in the center of the base, then through the body of the mounting bracket.

NOTE

Drop cable connectors are not waterproof.

6. Attach the base to the mounting bracket using the four screws (provided).

7. Reattach the camera module to the base.

8. Reattach dome cover.

9. Attach the mounting bracket with the camera to the bracket mounting plate after routing the end of camera drop cable

appropriately. Use the four screws provided with the bracket.

10. Connect the camera drop cable video and power leads to a video and power extension cable as needed. If using 12 Vdc to

power your camera, observe the polarity marked on the power drop cable when connecting the power extension cable.

CAUTION



When using 12 Vdc powering, use extreme caution to observe the polarity of the of the voltage applied to the camera.

The camera power drop cable connector center lead should receive +12 Vdc when measured to the shield (ground).

NOTE

Drop cable connectors are not waterproof.

11. Attach the far end of the video extension cable to video monitoring equipment such as a DVR.

12. Attach the far end of the power extension cable to a 12 Vdc or 24 Vac power source.

13. Apply power to the camera. Verify that video from the camera can be seen on the video monitor.

14. Remove the camera dome cover (for eld of view adjustments later).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Sin comentarios

Black BLK-CPV700R Manual de usuario Pagina 12