Black BLK-CPV700R Manual de usuario descargar pdf (Pagina 8)

SECTION 2: INSTALLATION

SECTION 2

Installation

2.1 General Guidelines

• Camera Lens: Handle the camera dome carefully to prevent scratching or soiling the dome and lens. If the dome or lens

becomes soiled, clean it only with approved products. See the Cleaning section later in this manual.

• Monitor impedance: Set the monitor impedance switch to 75Ω.

• Power supply: To avoid re or shock hazard, use only a UL listed power supply.

• Camera drop cable: The camera drop cable includes two connectors:

— Power connector (blue terminal block) – Use 24 Vac power source (AC24V 1A adapter) or 12 Vdc power source

(DC12V 1A adapter). When connecting 12 Vdc power to the camera power drop, observe the polarity shown on the

terminal block.

— Video coax connector (BNC, yellow sleeve) – for transmission of the video signal across coax (75 Ω) cable.

Video connector

Polarity indicators

Power terminals

Drop cable connectors

2.2 Mounting the camera

The camera can be mounted onto an electrical box, mounting bracket, or at surface with sucient strength to support it.

2.2.1 Mounting the camera onto a surface

When the camera is surface mounted, the drop cable can be routed through a hole in the center of the base and through the

mounting surface, or the side of the base. 3/4" conduit can be attached to either hole for the protection of the drop cable.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 34 35

Sin comentarios

Black BLK-CPV700R Manual de usuario Pagina 8