Black BLK-PTZ12X Guía de instalación descargar pdf (Pagina 90)

User Manual

 Record Stream to SD Card

Select the item and the alarm-triggered recording will be saved into

your Micro SD card.

Pre-trigger buffer recording function allows users to check what

happened to cause the trigger. The pre-trigger buffer time range is from

1 to 3 seconds. Select <Upload for __ sec> to set the recording

duration after alarm is triggered. The setting range is from 1 to 99999

seconds. Select <Upload during the trigger active> to record the

‘ triggered video until the trigger is off.

NOTE: Please make sure the local recording (with Micro SD/

SDHC card) is activated so that this function can be

implemented. Refer to 5.3.10 Recording for further details.

 Upload Image by E-Mail

Select this item and the Administrator can assign an e-mail address

and configure various parameters as shown in the figure below.

When the alarm is triggered, event images will be sent to the appointed

e-mail address.

<Pre-trigger buffer> function allows users to check what happened to

cause the trigger. The <Pre-trigger buffer> frame rate could be

pre-determined.

On the other hand, <Post-trigger buffer> is for users to upload certain

amount of images after alarm input is triggered.

Check the box <Continue image upload> to upload the triggered

images during certain time or keep uploading until the trigger is off.

Select <Upload for __sec> and enter the duration in the blank. The

images of the duration will be uploading by E-mail when the alarm input

is triggered. The setting range is from 1 to 9999 seconds. Select

<Upload during the trigger active> to make the images keep being

uploaded to E-mail during the trigger active until the alarm is released.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 164 165

Sin comentarios

Black BLK-PTZ12X Guía de instalación Pagina 90