Black BLK-HD4E Manual de usuario descargar pdf (Pagina 24)

SECTION 2: HARDWARE OVERVIEW AND SETUP

6. Reinstall the DVD mounting bracket with the DVD drive in the chassis using the four screws removed earlier.

7. Plug a SATA power cable from the cable bundle into the mating connector of the DVD drive.

8. Plug a SATA data cable to the back of the DVD drive. Plug the other end of the cable into a SATA connector on the PC board.

NOTE

SATA data interfaces on the PC board are labeled HDD1, HDD2, HDD3, etc. Not all are connectorized. Always use the lowest

numbered connectorized SATA data interfaces for the HDD drives in the DVR, and a higher numbered connector for the DVD drive.

For example, if HDD1 is not connectorized, but HDD2, HDD3 and HDD4 are, and two HDD drives are (or will be) installed in the

DVR, use HDD2 for the primary HDD drive, HDD3 for the secondary HDD drive, and HDD4 for the DVD-R/W drive. Connector labels

are marked on the PC board.

In the following example, HDD1 is not connectorized, an HDD drive data cable is plugged into HDD2, and the DVD-R/W drive

data cable is plugged into HDD3.

SATA

power

cable

DVD-R/W

SATA data

cable

HDD2 connector (HDD)

HDD3 connector (DVD R/W)

9. If you are installing HDD(s) in the DVR at this time, continue with “2.5.4 BLK-HD10D, BLK-HD16D HDD installation” on page 24.

Otherwise, go to “SECTION 3 System Setup” on page 28.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 123 124

Sin comentarios

Black BLK-HD4E Manual de usuario Pagina 24