Black BLK-HD4E Manual de usuario descargar pdf (Pagina 32)

SECTION 2: HARDWARE OVERVIEW AND SETUP

5. Insert the grommets provided in the hardware kit in the slots in the upper or lower drive slot.

HDD upper

drive slot

HDD lower

drive slot

Grommets

Special screws

Retaining

screw hole

HDD

mounting

bracket

HDD drive

connectors

6. Place the HDD in the slot with the connector end toward the bracket end with the retaining screw hole, then secure the drive

to the bracket with the four special screws provided, two on each side of the bracket. Tighten the screws until snug.

7. If installing a second HDD drive, repeat the previous two steps for the other drive slot.

8. Reinstall the HDD mounting bracket with the HDD drive(s) in the chassis. Slide the three tabs on the underside of the bracket

into the three slots in the chassis, then secure the bracket with the retaining screw.

CAUTION



The HDD mounting bracket be installed over the front panel ribbon cable. Do not damage the cable, or dislodge it from its

connectors, especially the connector on the back of the front panel.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 123 124

Sin comentarios

Black BLK-HD4E Manual de usuario Pagina 32