Black BLK-HD4E Manual de usuario descargar pdf (Pagina 30)

SECTION 2: HARDWARE OVERVIEW AND SETUP

4. Connect the HDD SATA data cable (blue) to the SATA1 connector on the PC board.

5. Connect the HDD SATA power cable to one of the mating connectors on the PC board.

NOTE

In a DVR with 2 HDDs, the primary HDD is connected to the SATA0 connector and the secondary HDD is connected to the SATA1

connector.

2.5.4 BLK-HD10D, BLK-HD16D HDD installation

Your DVR will accommodate standard desktop system HDDs with a SATA interfaces. If installing more than one HDD in your DVR,

they may must be the same brand and model. If your DVR was purchased without an HDD, a hardware kit is included with the DVR.

To install an HDD, carefully follow the procedure below.

CAUTION



Follow recommended electrostatic discharge (ESD) guidelines while performing this procedure. Install the HDD in a static-free

environment, wearing a certied ESD wrist strap. If a static free environment and ESD wrist strap is not available, touch the bare

metal of the DVR chassis frequently when installing the drive to dissipate the static charge naturally generated on your skin and

clothing.

1. If your DVR is powered on, use the menu system to perform a System Shutdown.

a. Right click anywhere on the live view screen, then click SYSTEM SHUTDOWN in the pop-up menu (see “SECTION 3

System Setup” on page 28), or click the SYSTEM SHUTDOWN icon on the task bar.

b. Follow the on-screen instructions for shutting down the system.

2. Disconnect the power cord from the back of the DVR.

3. Remove the top cover from the DVR by removing the two cover screws on the back of the chassis, and the two on each side.

See the drawing below.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 123 124

Sin comentarios

Black BLK-HD4E Manual de usuario Pagina 30